Invalid hash message on XRPtoolkit

[Garland]

Hello I am trying to prepare for the flare fork with my xrp and nano. I created a MEW and did all the steps on XRPtoolkit, I got my "message key" but when I go to add that to account properties on XRPtoolkit, it says "invalid hash" meaning I cant complete it. Been goolging and trying for over 3 hours. Does anyone know what this message means or how to fix it? I have DMed the staff on Twitter but really would like to fix this

[Flintstone]

You should be good if you follow these instructions https://coil.com/p/wietse/Prepare-for-claiming-your-Spark-token-Flare-Networks-a-tool-for-XUMM-XRPToolkit/NkXJQUqpi

[Sharkey]

37 minutes ago, Flintstone said:

You should be good if you follow these instructions https://coil.com/p/wietse/Prepare-for-claiming-your-Spark-token-Flare-Networks-a-tool-for-XUMM-XRPToolkit/NkXJQUqpi

Agree, I used this process and it was easy and smooth.

[jargoman]

On 9/20/2020 at 2:39 PM, Garland said:

Hello I am trying to prepare for the flare fork with my xrp and nano. I created a MEW and did all the steps on XRPtoolkit, I got my "message key" but when I go to add that to account properties on XRPtoolkit, it says "invalid hash" meaning I cant complete it. Been goolging and trying for over 3 hours. Does anyone know what this message means or how to fix it? I have DMed the staff on Twitter but really would like to fix this

Invalid hash means that a transaction is being signed so chances are you are using a valid ripple secret to sign. Therefore it's the message key that is invalid. 

Possible reasons:

1.
It's not a valid hexadecimal. That's the most likely cause. Valid hex digits are: 0123456789ABCDEF
Common mistake would be to type the letter O instead of zero. Lower case L instead of 1. 

2.
Other possibility is you didn't remove 0x from the beginning and add 02000000000000000000000000 (I don't know if XRP toolkit does this for you)

3.
You are missing one of the characters. It should be 02 + 24 zero's + 40 hexadecimal characters, therefore would be 66 characters long.

4.
You are trying to add you eth private key instead of the public key. 


 

[BillyOckham]

5 hours ago, jargoman said:

You are trying to add you eth private key instead of the public key. 

@Garland If it turns out to be the above,  discard that address and start again.  The transactions are there forever...  so consider that key burnt.